CRANE Cast Steel Gate Valves
Crane Gate valves serve as efficient stop valves with flow in either direction. They are commonly used where a minimum pressure drop is important. Throttling is not recommended because partially open gate valves exhibit flow characteristics not conducive to accurate and consistent flow control. Also, the valves may be damaged by the high velocity across the seats. They function best fully open or fully closed.
Gate Valve
Outside Screw & Yoke ● Flexible Wedge Disc
150 | 2 through 24 inches (50 – 600 mm) | Carbon Steel, ASTM A216 Grade WCB 285 psi @ -20°F to 100°F to a maximum of 800 °F (20 bar @ -28°C to 37°C) |
300 | 2 through 24 inches (50 – 600 mm) | Carbon Steel, ASTM A216 Grade WCB 740 psi @ -20°F to 100°F to a maximum of 800 °F (51 bar @ -28°C to 37°C) |
600 | 2 through 12 inches (50 – 300 mm) | Carbon Steel, ASTM A216 Grade WCB 1480 psi @ -20°F to 100°F to a maximum of 800 °F (102 bar @ -28°C to 37°C) |
Features
Flexible Wedge
- Compensates for deformation of body due to pipe stresses.
- Will not stick when valve is closed hot and allowed to cool.
Welded-in Seat Ring
- Seat ring is seal welded to eliminate leak path.
Materials of Construction
Steel bolted bonnet valves described here are typically manufactured of carbon steel. When specified, the valves are available in the alloys which are suitable for steam, water, oil, oil vapor, gas and general services.
- A217 WC6
- A217 WC9
- A217 C5
- A217 C12
- A352 LCC
- A351 CF8M
- A351 CF8
Certified Quality
These valves comply with the applicable requirements of the following standards:
- API 600
- API 598
- ASME B16.34
- ASME B16.25
- ASME B16.10
- ASME B16.5
- CRN
Gear Actuators recommended for Crane Gate valves:
- Class 150: sizes above 10″
- Class 300: sizes above 8″
- Class 600: sizes above 6″